Peel tester is mainly applicable to various physical and mechanical properties testing of plastic sheet, pipe, profile, plastic film and rubber, wire and cable, waterproof coil, metal wire and other materials. Tensile tester is used for metal materials and non-metal materials. Tests such as stretching, compression, bending, shearing, and peeling are performed. For this kind of multi-functional equipment, it must be maintained more in order to make the test data more accurate. The following Kunshan Haida instrument to introduce you to the stripping tester how to maintain and maintain.
Peel tester maintenance and care procedures:
1. Peel Tester Prior to testing, the system must be preheated more than 20 minutes in advance to minimize temperature effects.
2. The buffer oil should be kept clean. If the oil level is less than two-thirds of the depth of the barrel, it should be replaced immediately.
3. Before starting the tension strength tester, check whether the frictional active parts should be filled with lubricating oil.
4. Before holding the test piece, the brake handle must be stuck, and then add the test piece and release it.
5, dynamometer main bearings do not allow refueling. The surface of the friction wheel in the gearbox must not be oiled or splashed with oil. The friction surface must be clean and clean, and the bevel block on the swing arm must not be violently impacted.
6, after the test is completed, cut off the power, then give the test machine for surface cleaning, timely protection, to prevent surface rust.
7, on average every month to 2 to 3 times maintenance of the pulling machine.
Stun Gun ,
ZHEJIANG ZHOUHE TECHNOLOGY CO.,LTD , http://www.zohetech.com