As we all know, the compound salt spray test chamber is produced by the air compressor to enter the saturation barrel for humidification heating and oil filtration, the nozzle generates atomization to form a spray, and then the tower spray device and the non-crystallizing nozzle enter the metering cylinder to facilitate customers Check the amount of salt spray collected during the test. There is a standard configuration of the salt spray test box. The following are the points listed by the editor:
1. Round bar: each bearing 1.5kg, the tested sample can be placed flat on it. If the tested piece is too small, the tested sample can be tied with nylon rope and tied to the round bar for testing.
2. V-shaped sample holder: each bearing 5kg, can be tilted at 15 ° C ~ 30 ° C. If the sample needs to be laid flat on the test, the round bar can be removed and placed flat on the V-shaped sample holder for testing ,
3. Tower sprayer with no crystallizing nozzle and metering cylinder is used for the accuracy of the salt spray settlement during the test. The nozzle is easy to block due to the small aperture. Once blocked, or the nozzle's diversion tube is attached due to oil contamination etc. Narrowing will not form the ideal salt spray. Therefore, pure water must be used in the experiment. Remember, tap water cannot be used.
Polyester Screen Mesh,Good Use Polyester Screen Mesh,Stretch Polyester Screen Mesh,White Polyester Screen Mesh
shaoxing gesheng wire mesh co., ltd , https://www.gscreenmesh.com