First, the reason for the arc of the board edge: 1. The track pressure on both sides is inconsistent, or the pressure on both sides of the drum is inconsistent. 2. The method of solving the plywood on one side of the plywood: 1. Adjust the pressure 2. Check the kerf, replace the saw blade 2, and the two sides are not parallel: 1. The warp of the plywood is too large. 2. The position of the saw blade is not fixed. 1. After the plywood is flattened and then sawed, the machine is stopped and the position of the saw blade is adjusted. 3. The cause of the saw or the edge of the board is: 1. The feeding speed is too fast 2. The sawtooth material is too narrow, the tooth groove is too shallow 3. The cutting speed of the saw blade is low. 1. Adjust the feeding speed 2. Increase the material, deepen the groove 3, increase the cutting speed 4. The saw blade has a small diameter or a low speed. The reason for the rough edge is: 1. The eccentricity of the saw blade is 2, the sawtooth height is different, not on the same circumference, the saw blade warps and shakes 3, the individual sawtooth is not accurate 4. The feed speed is too fast 5. The sawtooth grinding angle is not solved correctly: 1. Check and correct the saw blade installation state 2. Check the saw blade, align the tooth tip, correct the saw blade 3, correct the sawtooth material 4, grind the sawtooth as required, and cause the burr to break. 1, the serrated sharpening is not sharp 2, the plywood is pressed too tight (drum type) 3, the saw blade is too large, there are flying teeth 4, the military report that the moisture content is too low to solve: 1. Re-sharp or replace the sharp saw blade 2, adjust the pressing device 3, check the saw blade, correct the material 4, check the moisture content of the plywood, and the cause of the skewing of the kerf: 1. The baffle is not installed correctly. 2. The method of softening and shaking in the middle of the saw blade: 1. Correct the baffle position 2. Replace the saw blade and re-level the saw blade
wood pulp for sanitay pads
The descriptions of Wood Pulp For Sanitary Pads:
After bleaching, take out the organic solvent after the operation of the wood pulp, straw pulp. Is a kind used to produce all kinds of hygiene products
Material: wood pulp
Length: 245mm
Anion chip: blue
Free sample: available
FAQ
(1) Do you accept small order?
Yes,we do. We are having ready stock available now.
(2) Visit of factory?
Yes, warmly welcome a visit of our factory anytime.
(3) Free sample?
Yes, Free samples available.
(4) Other hot product
Now. our the most popular product have the Far-infrared Sanitary Pad, herbal medicine Sanitary Napkin, Fruit series santary towel and so on. if you want to know more popular product, please leave us a message.
Wood Pulp For Sanitary Pads
Wood Pulp For Sanitary Pads,Wood Pulp For Ladies Sanitary Pads,Soft Wood Pulp For Sanitary Pads
Glory Power Hygiene Products Ltd. , https://www.hygienenapkin.com